Idiomas disponibles
Idiomas disponibles
44
BEFORE REQUESTING SERVICE
Symptoms and Questions
Too much smoke during the self clean cycle.
The oven door does not open after a self clean cycle.
The oven door is not clean after a self clean cycle.
"CLOSE DOOR TO CONTINUE BROILING" or "DOOR
OPENED" appears in the display.
"DOOR LOCKED" message appears when you want to cook. The oven door is locked because the temperature inside of the
Oven control beeps and displays an F error code.
The oven racks were cleaned in a self clean cycle.
Clock is flashing.
"Burning" or "oily" odor emitting from the vent.
Strong odor.
Fan noise
Convection fan not working.
Burners are not lighting properly after cleaning the cooktop
surface.
When lighting just one burner, clicking noise is heard from
all the burners.
PF(Power Failure) displayed
/ Display Time is flashing
Possible Cause/Solution
Too much soil in the oven. Open the windows to get rid of the
smoke from the room. Press the
m light goes off before trying to open the oven door. Wipe up the
excess soil and reset the clean cycle.
The oven temperature is too high. Wait up to one hour to cool
down.
Incorrect oven control settings. See "SELF CLEAN" in the Care
and Cleaning section.
The oven was heavily soiled. Clean up heavy spills before begin-
ning the self clean cycle. Heavily soiled ovens may need either a
longer self clean or two self clean cycles.
Close the oven door.
oven is too high. Press the
Press the
or
key and wait for one hour.
Check the main gas shut-off valve or the oven gas shut-off valve
and call for service.
Remove the power from the range for five minutes and then
reconnect the power. If the function error code repeats, call for
service.
Apply a small amount of vegetable oil to a paper towel and wipe
the edges of the oven racks. Do not use lubricant sprays.
Power outage or surge. Reset the clock. If the oven was in use, you
must reset it by pressing the
and any cooking function.
This is normal in a new oven. To speed the process, set a self clean
cycle for a minimum of three hours. See "SELF CLEAN" in the
Care and Cleaning section.
An odor from the insulation around the inside of the oven is normal
for the first few times the oven is used.
The convection fan may turn on and off automatically.
This is normal.
The preheating temperature has not been reached. The Fan will
start automatically once the preheating temperature is reached.
Make sure that the burner heads and caps are completely dry and
properly positioned.
This is normal. Electric spark igniters from the burners cause the
clicking noise. All the spark igniters on the cooktop will activate
when igniting just one burner.
Depending on the model of your range, the display will either show
"PF" or a flashing clock. This means that the product has just been
plugged in, or that it has experienced a power interruption. To clear
the "PF" message, press the "Clear/Off" key on the oven controls.
If your oven displays a flashing clock, then press the "Clock" key
and reset the time, or press any key to stop flashing.
or
key. Wait until the
or
key.
or
key. Reset the clock
