Idiomas disponibles
Idiomas disponibles
OPERATION
Never adjust the amplifier to a very high volume. Permanent high volumes may damage
your hearing!
Your ear will get accustomed to high volumes which do not seem to be that high after some
time. Therefore, do not further increase a high volume after getting used to it.
To prevent switching noise, always switch on the units connected before switching on the
amplifier and always switch off the amplifier before switching off the other units.
1. Before switching on the amplifier for the first time, turn the total volume control VOLUME
(8) to the left stop.
2. Use the POWER switch (1) to switch on the amplifier.
3. Turn up the control VOLUME (8) to adjust the total volume desired; for each audio source
to be heard, adjust the volume by means of the appropriate control:
– control MIC LEVEL (5) for the microphone connected to the input MIC (2)
– control LINE LEVEL (7) for the unit connected to the input LINE IN (10)
– control AUX / MP3 LEVEL (6) for the unit connected to the input AUX (3) or, when the
input AUX is not used, for the combination "MP3 player / FM radio / Bluetooth receiver" (4)
Note: The basic volume of the combination "MP3 player / FM radio / Bluetooth receiver"
can be additionally adjusted
4. Use the controls TREBLE and BASS (9) to adjust the tone.
MP3 PLAYER / FM RADIO / BLUETOOTH RECEIVER
When the ZZONE200SA is switched on, the combination "MP3 player / FM radio / Bluetooth
receiver" will automatically be activated and go to the mode "Player". When no storage
medium is connected, NO SOURCE will appear on the display (16). When a storage medium
is already connected, it will be read and then reproduced. When two storage media are
connected, the USB medium will be selected after the ZZONE200SA has been switched on.
The infrared remote control provided with the amplifier includes the battery required.
Remove the protective film from the battery holder prior to initial operation. When pressing
a button, always point the remote control to the infrared sensor (15). Make sure that there
are no obstacles between the remote control and the sensor.
If the remote control is not used for a longer period of time, remove the battery as a
precaution so that the remote control will not be damaged in case the battery should leak.
Replacing the battery:
1. Push the latch of the battery holder to the right and pull out the holder
2. Remove the discharged battery and insert the new battery (3 V button cell, type CR 2025)
in the holder, positive pole facing upwards.
3. Push the holder back into the remote control.
5
