TRAPP TRC-40 Manual De Instrucciones página 28

4
7
8
9
12
11
13
Image merely illustrative
To remove the blades, proceed as follows:
Remove the bolt (1), the plain washer (2) the upper

blade (3), the intermediary blade (4) and the
intermediary blade (5).
28
Cutting Blades Maintenance
1
2
3
5
6
10
Next, remove the separator of 16 mm (6), and the

intermediary blade (7).
Then remove the hexagon bolts (8), the lock washer

(10), the hex nuts (11), the blade holder (12) and the
lower blade (9).
Check the shank (13) alignment before completing

the assembly of the blade assembly, if necessary
align the shanks to avoid excessive vibration of the
cutter assembly.
Assemble the blades in the same direction and

position as shown in the side picture to ensure that
the cutter assembly is working; incorrectly mounting
the blades may damage the equipment and cause
loss of warranty.
Before turning on the machine after assembling the
blades, manually rotate the cutter assembly and
check that it runs clear from any part of the crusher.
If you notice an excessive vibration when starting
the crusher, check the blade assembly step; if you
still have problems, call a TRAPP Service
Technician.
Note: Blades should be replaced when the sharp area
advances by 20% of the cutting area.
Faca A ada
Sharp knife
Faca A ada
Image merely illustrative
www.trapp.com.br
Faca Gasta
Blunt knife
Faca Gasta