Idiomas disponibles
Idiomas disponibles
INSTALLATION
CARRIAGE INSTALLATION (continued)
Fig. 1a
FOOTREST INSTALLATION
plate
safety
plate
©Bruno Independent Living Aids, Inc.
17. Using remote transmitter, power carriage
Fig. 1b
1. Before mounting footrest, turn circuit
2. Remove downside M10 button head screw
3. Insert this button head screw in open hole
4. Mount footrest to carriage by inserting
Fig. 2
20
®
approximately 12" (30 cm) onto gear rack.
NOTES: In left-hand installations, power
carriage slowly, allowing over-
speed gear to align with gear
rack .
While jogging carriage on rail
with remote, if overspeed gear
"clunks" against gear rack, and
carriage stops, manually ease
carriage toward end of rail, just
far enough to provide access
to overspeed gear. Use a finger
to turn overspeed gear past a
few teeth . Try again to power
carriage onto gear rack using
remote (Figs . 1a, 1b) .
breaker OFF.
securing front cover during shipping.
on upstairs side of front cover, next to its
mate.
three (3) M10-25 hex head
cap bolts and three (3)
safety washers.
Insert one (1) washer through top of plate
and two (2) through safety plate (Fig. 2).
DO NOT TIGHTEN AT THIS POINT!
SRE-3000 INSTALLATION 02-08-2019
