Appliance Door; Removing And Installing The Door Panels - Siemens VB558C0S0 Instrucciones De Uso

Appliance door

en
qAppliance door
W ith good care and cleaning, your appliance will retain
A p p l i a n c e d o o r
its appearance and remain fully functional for a long
time to come. This will tell you how to clean the
appliance door.

Removing and installing the door panels

To facilitate cleaning, you can remove the glass panels
from the oven door.
Removing the door panels
Open the oven door fully.
1.
Lock both hinges on the left and right using the
2.
locking pin.
The locking pins must be fully inserted into the
Note:
holes in the hinges.
Lift the bottom of the inner panel slightly until the
3.
fastening pins come out of the holder (1).
Carefully lift the top of the inner panel until the
4.
fastening pins come out of the holder (2).
Caution!
When lifting the inner panel, the middle panel may
stick to the inner panel. Make sure that the middle
panel does not fall.
Remove the inner panel.
5.
18
Remove the middle panel.
6.
The middle panel is kept in place with rubber
Note:
bushings rather than retaining pins.
Clean the panels with glass cleaner and a soft cloth.
:
Warning – Risk of injury!
Scratched glass in the appliance door may develop into
a crack. Do not use a glass scraper, sharp or abrasive
cleaning aids or detergents.
Fitting the door panels
Reinsert the middle panel.
1.
Notes
– If the Low-E symbol can be read, the middle
panel is inserted correctly.
– Make sure that the panel is seated correctly. All
rubber mounts must lay flat against the outer
panel.
Reinsert the inner panel.
2.
All four fastening pins must engage in the
Note:
holders provided for them.
Remove the locking pins and close the oven door.
3.