Idiomas disponibles
Idiomas disponibles
Product information
Service overview
Service recommendations
Preventive maintenance is recommended at regular intervals. See the detailed
information on preventive maintenance. If the product is not working properly,
take it out of service and inspect it.
If no detailed information about preventive maintenance is included, follow
these general guidelines:
• Clean appropriate parts accurately
• Replace any defective or worn parts
ATEX certification information
Temperatures
• The maximum surrounding temperature for which the certification is valid
is 40°C.
• 40°C is also the maximum allowed temperature of the compressed air when
it enters the product.
• If the product is installed in an equipment, the entire equipment has to corre-
spond to the guidelines 2014/34/EU.
• Make sure that the compressed air fulfil our quality demands (quality
classes 2.4.3. and 3.4.4 respectively 3.5.4 acc. to ISO/DIS 8573-1).
• Do not exceed maximum pressure of 6.3 bar, or as stated on the product
nameplate. Exceeding the operating pressure can increase the surface tem-
perature due to higher rotating speed and the product can become an igni-
tion source.
Ex Classification
If the product is part of an assembly where the components have different Ex
classification, the component with the lowest level of safety defines the Ex clas-
sification of the complete assembly.
ATEX code definition
The ATEX code is:
Description
Equipment group
Equipment category
Group II
8
EN
Value
II
2
© Atlas Copco Industrial Technique AB - 9839 0861 00
LLA1000-U-EX
Definition
Surface Industry
High level of protection
• zone 1 (gas)
• zone 2 (gas)
• zone 21 (dust)
• zone 22 (dust)
