hillvert HT-RTT-650 Manual De Instrucciones página 47

 Place shift lever indicator in "F" (forward) position. Tines will not turn.
 Lift handle to raise tines out of ground.
 Swing the handle in the opposite direction you wish to turn, being careful to keep feet and legs away from tines.
 When you have completed your turn-around, release the drive control bar and lower handle. Place shift lever in
appropriate position and move throttle control to desired speed. To begin tilling, hold drive control bar against the
handle.
3.4.11. Cultivating
Cultivating is loosening or digging around growing plants to disrupt weeds and aerate soil. Less than 50mm (2") depth is
always desirable.
 Place shift lever indicator in forward rotating (
 Move both the depth stake pin lever and the drag stake pin lever to the unlock position. Hold the depth stake limiter
to pull the depth stake up for increasing tilling depth. Place depth stake pin in the hole of the depth stake to lock in
position at desired depth. Lower drag stake to the "Lowered position" and lock it in position.
 Hold the drive control bar against the handle to start cultivating movement. Tines and wheels will both turn.
 Move the throttle control to the fast position for deep cultivating. To cultivate, throttle control can be set at any
desired speed, depending on how fast or slow you wish to cultivate.
 Always lower the drag stake when using the forward rotating tine drive.
3.4.12. Outer Side Shields
To protect small plants from being buried while tilling, the back edges of the outer side shields are slotted so that the shields
can be raised for deep tilling and lowered for shallow tilling. To move the shield to the desired position (both sides), Loosen
Nut A and Nut B, move the shield, and retighten the nuts.
3.4.13. Stopping The Tines And Drive
 Release drive control bar to stop movement.
 Move shift lever to "N" (neutral) position.
3.4.14. Transport Around The Yard
CAUTION: Before lifting or transporting, allow tiller engine and muffler to cool. Disconnect spark plug wire. Drain gasoline
from fuel tank.
 Release the depth stake pin. Move the depth stake down to the second top hole for transporting the tiller. Place
depth stake pin in hole of depth stake to lock in position. This prevents tines from scuffing the ground.
 Place shift lever indicator in "F" (forward) position for transporting.
 Hold the drive control bar against the handle to start tiller movement. Tines will not turn.
 Move throttle control to desired speed.
3.4.15. Idle Speed
Set the throttle control lever to the SLOW position to reduce stress on the engine when work is not being performed.
Lowering the engine speed will help extend the life of the engine, as well as conserve fuel and reduce noise level.
) position when cultivating soft ground or tilling pre-tilled soil.
1 – Outer side shields
2 – A nut
3 – B nut