Idiomas disponibles
Idiomas disponibles
3.3.12. Choke Control
The choke control is used to choke the carburettor and assist in starting the engine. The choke control slides between the
CHOKE CLOSED and CHOKE OPEN positions.
3.4.
WORK
3.4.1. Add Oil To Engine
The engine is shipped without oil. Do not start the engine before adding oil. Refer to your engine manual for the
proper oil gauge to use.
Make sure the rear tine tiller is on a flat, level surface.
Remove the oil fill cap/dipstick to add oil.
Using a funnel, add oil up to the FULL mark on the dipstick. (See engine manual for oil capacity, oil recommendation,
and location of fill cap.).
DO NOT OVERFILL. Check engine oil level daily and add as needed.
3.4.2. Add Gasoline To Engine
Gasoline is highly flammable and explosive. You can be burned or seriously injured when handling fuel. Use
extreme care when handling gasoline.
Fill the fuel tank outdoors, never indoors. Gasoline vapours can ignite if they collect inside an enclosure. Explosion
can result.
The engine must be off and allowed to cool at least two minutes before adding fuel. Remove the fuel filler cap and fill the
tank.
IMPORTANT: DO NOT OVERFILL!
This equipment and/or its engine may include evaporative emissions control system components, that will only function
properly when the fuel tank has been filled to the recommended level. Overfilling may cause permanent damage to
evaporative emissions control system components. Filling to the recommended level ensures a vapor gap required to allow
for fuel expansion. Pay close attention while filling the fuel tank to ensure that the recommended fuel level inside the tank
is not exceeded. Use a portable gasoline container with an appropriately sized dispensing spout when filling the tank. Do
not use a funnel or other device that obstructs the view of the tank filling process.
Reinstall the fuel cap and tighten. Always clean up spilled fuel.
3.4.3. Starting Engine
Open the fuel shut-off valve:
Never use choke to stop engine.
