To Start The Engine - Craftsman 580.328310 Instrucciones De Uso

To Start The Engine
CAUTION
See "Don't Ovedoad Generator".
Start generator
and let engine
stabilize
before
connecting
electrical loads.
Connect electrical loads in OFF position, then turn ON
for operation.
Turn electrical loads OFF and disconnect from generator
before stopping generator.
iMPORTANT: Always unplug the battery float charger
before starting the generator.
Disconnect all electrical loads from the generator. Use
the following start instruction steps by numerical order:
1. Make sure unit is on a level surface.
iMPORTANT: Failure to start and operate unit on a
level surface will cause the unit not to start or shut
down during operation.
2. Turn fuel valve to "On" position. Fuel valve handle
should be vertical (pointing toward the ground) for
fuel to flow.
Fuel Valve is shown
in the On position
3. Make sure Idle Control switch is in "Off" position.
IDLE
4. Set Ignition switch to "On" (-) position.
5. Pull choke control out to close choke.
6A. For electric starting, press start switch on
generator cradle until engine starts. To prolong life
of starter components, press starter button for no
more than 5 seconds, then pause for 1 minute.
• If engine starts, proceed to step 8.
• If engine fails to start, proceed to step 7.
NOTE: If battery is discharged, use manual starting
instructions.
6B. For manual starting, grasp recoil handle and pull
slowly until slight resistance is felt. Then pull
rapidly one time only to start engine.
• If engine starts, proceed to step 8.
• If engine fails to start, proceed to step 7.
WARNING
When starting engine, pull cord slowly until resistance is
felt and then pul! rapidly to avoid kickback.
NEVER start or stop engine with electrical devices
plugged in and turned on.
7. Push in the choke handle half way, and pull recoil
handle twice.
• If engine fails to start, repeat steps 5 thru 6.
8. Open the choke gradually as the engine warms up
by pushing in on the choke handle.
NOTE: If engine starts after 3 pulls but fails to run, or
if unit shuts down during operation, make sure unit is
on a level surface and check for proper oil level in
crankcase. This unit may be equipped with a low oil
)rotection device.
WARN NG
DO NOT touch hot surfaces.
Allow equipment to coo! before touching.
The generator must be at least 5 feet from structures having
combustible wails and/or other combustible materials.
Keep at least 3 feet of clearance on all sides of generator
for adequate cooling, maintenance and servicing.
In the State of California a spark arrester is required by
law (Section 4442 of the California Public Resources
Code). Other states may have similar laws. Federal laws
apply on federal lands. If you equip the muffler with a
spark arrester, it must be maintained in effective working
order.You can order a spark arrester through your
authorized Sears service dealer.
10