Idiomas disponibles
Idiomas disponibles
The outdoor enclosure is designed to house the control unit, the toroidal transformer
and any buffer batteries (Optional).
To secure the toroidal transformer and the board support, consult the specific instruc-
tions.
To secure the control board, follow the instructions below:
1. Position the supplied spacers (Fig.03 ref.a) on the columns identified by the following
letters: D-L-O-P-R-H-E.
2. Secure the board using the supplied screws (Fig.03 ref. b).
The spacer positioned next to letter O serve only for supporting the board.
3. Wire up according to the connection lay-out (paragraph 13).
4. To position and wire the battery kit, refer to the relevant instructions.
If you are using the battery kit, you MUST clear the pre-perforated hole in the lower
part of the enclosure (Fig.04 ref. a) as requested by current safety laws.
14. HOW TO SECURE THE BOARD
20
Fig. 04
Fig. 05
