GYS NOMAD POWER PRO TRUCK Manual De Instrucciones página 11

Translation of the original instructions
LCD DISPLAY DESCRIPTION
2
4. The power display:
Press switch button
battery has a XX% of the electricity; 100%, indicates that full power; display «BATTERY LOW RECHARGE», indicates that NOMAD POWER power is low, please charge.
2. The products charge:
NOMAD POWER connected to home or car charger charge, «CHARGING» light turns on LCD,
displays «CHARGING», and displays the current battery power.
3. LED lighting display:
Pressing NOMAD POWER LED light switch
follows: lighting modes: Show LIGHT; Strobe Mode: Displays FLASH; SOS mode: the SOS
closed.
4.USB output display:
5 V - 2.1 A / 1 A USB output
cable and press the power button.
The display shows: «USB1 USB2 ON», then it can be used to charge for give mobile phones,
tablet computers and other digital products.
5. Output reverse show:
It shows that car battery are connected incorrectly when «WARNING CLAMPS REVERSES
CHECKALL CONNECTIONS» appears in screen. At this time, the start is prohibited. And remove
the jumper cable, connect again in correctly terminal (the red clamp is connected positive (+)
and the black is connected negative (-) terminal). If the question is not lifted, please keep
pressing power button 3 seconds to deal with question.
6. Output short-circuit show:
It shows that car battery are short circuit of output when «WARNING SHORT CIRCUIT CHECK
ALL CONNECTIONS» appears in screen. At this time, the start is prohibited. And remove the
jumper cable, and keep pressing power button
be dealt with, pleasecall professionals to check.
7. 12 V / 24 V output display:
1. Press 12 V key
2. Press 24 V key
USING A JUMP START
Charging instructions
It is best to charge the Nomad Power at a temperature > 10°C. If the temperature is below 0°C, do not
charge the Nomad Power. Place the Nomad Power in a temperate room for 1 hour before charging.
!
Before storing a NOMAD POWER for an indefinite period of time :
- Do not charge it to 100%, but rather between 60 and 80%.
- Every 6 months, perform a 100% charge to keep its performance intact.
1. Connect the USB cable with the home adaptator and then plug the home adaptator into the universal socket.
2. Connect the Micro connector to the NOMAD POWER host
NOMAD POWER PRO TRUCK
display «BATTERY», also shows the host power. XX%, indicates that the
3
: When 5 V - 2.1 A / 1 A USB output port connected to the USB
11
, displays «12 V JUMP START READY»;
5
, displays «24 V -JUMP - -START READY».
6
can turn on and off different lighting modes, as
4
3 s to deal with question. If question not to
3
9
.
EN
11