Parkside PWSAP 20-Li D4 Traduccion Del Manual De Instrucciones Originales página 77

Safety guidelines for battery
chargers
This tool may be used by children
■
aged 8 years and above and by
persons with limited physical,
sensory or mental capabilities or
lack of experience and knowl-
edge, provided that they are
under supervision or have been
told how to use the tool safely
and are aware of the potential
risks. Do not allow children to
use the tool as a toy. Cleaning
and user maintenance tasks may
not be carried out by children
unless they are supervised.
To avoid potential risks, dam-
■
aged power cords should be
replaced by the manufacturer,
their customer service department
or a similarly qualified person.
The charger is suitable for indoor
use only.
WARNING!
■ To avoid potential risks, damaged power
cords should be replaced by the manufacturer,
their customer service department or a simi-
larly qualified person.
ATTENTION!
♦ This charger can only charge the following
batteries: PAP 20 A1/PAP 20 A2/
PAP 20 A3/PAP 20 B1/PAP 20 B3/
PAPS 204 A1/PAPS 208 A1.
♦ A current list of battery compatibility can
be found at www.Lidl.de/Akku.
PWSAP 20-Li D4
Storage and handling of the recom-
mended accessory tools
■ Grinding tools must be treated with care and
transported carefully.
■ Grinding tools should be stored in such a way
that they are not exposed to mechanical dam-
age or environmental influences (e.g. damp).
Working procedures
NOTE
► Grinding tools should only be used for the
recommended applications. Otherwise, they
can break, be damaged or cause injuries.
Rough grinding
Never use cutting discs for rough
grinding!
■ Move the angle grinder with moderate
pressure back and forth over the workpiece.
■ For soft material, move the roughing disc at
a flat angle over the workpiece; for hard
material at a slightly steeper angle.
Abrasive cutting
Never use roughing discs for
cutting!
■ Use only tested fibre-reinforced cutting or
grinding discs that are approved for a
peripheral speed of not less than 80 m/s.
CAUTION!
► The grinder continues running after being
turned off. Do not try to brake it by applying
lateral counterpressure.
■ Secure the workpiece. Use clamps/vices to
hold the workpiece firmly in place. This is much
safer than simply holding it in your hand.
■
Always switch off the tool before putting
it down and wait for the tool to come to a
complete standstill.
GB │ MT │ 69 ■