10. HOB FUNCTIONS
Child lock
Lock
Boost function
Cooking zone
timer
This function prevents accidental use of the appliance. This cannot be used during a cooking oper-
ation
To enable: remove all cookware from the appliance, turn the appliance off. f there is no pan on the
hob, press and hold for 3 seconds one of the digits (not visible) next to point
lease and slowly swipe along the power bar from 0 to BOOST. All the digits that indicate
The operations described must be completed within 10 seconds.
To disable: turn the appliance on and then press and hold any of the 5 digits for 3 seconds. Re-
lease and slowly swipe along the power bar from BOOST to 0. The 5 digit displays will lit up indicat-
ing and 0 power level.
The operations described must be completed within 10 seconds.
It is possible to lock the hob functions during use, e.g. to clean the hob. The function is enabled
even if the hob is switched off and on again.
If the electricity supply is cut, the function is disabled.
To enable: press
and hold for 1 second.
To disable: press
.
Every cooking area can be set to an additional power level for a maximum of 5 minutes.
To enable: select one of the 4 cooking areas and select "P" on the power bar. The corresponding
digit indicates
.
To disable: select one of the other possible values on the power bar.
The timer allows a specific cooking area to be switched off when the set time expires.
The cooking areas can be programmed individually because each one has its own timer.
To enable: With the cooking area in operation, press to access the timer management controls for
that zone.
The 3 digits indicate "0 0 0". Press "+" or "-" to set the timer countdown.
To confirm the set time, do not touch anything for 10 seconds.
When the countdown has finished, the digits are reset and an audible signal is emitted. The func-
tion can be interrupted by pressing any key.
If the timer is enabled for more than one cooking area, the 3 digits will always show whichever timer
is about to finish first.
To deactivate: with the cooking area in operation, press to access the timer management controls
for that zone.
Set the three digits to "0 0 0" using "+" or "-" or press the On/Off key.
Hours - Tenths - Minutes
on the left side. Re-
.
11