Idiomas disponibles
Idiomas disponibles
Reversibility Kit Instructions
If your model came with a Reversibility kit, please use the Brand
Badge Placement template and the following instructions to
install the Brand Badge on the opposite side of the freezer door.
Parts Included:
Brand badge removal tool
Brand badge template (on last page of User Instructions)
Door handle hole plug
Tools Needed:
Scissors
Masking tape
Freezer Door
1. Using the removal tool (provided), remove the brand badge
from the freezer door by lifting up the right-hand side and
peeling the badge away from the door from right to left.
NOTE: To avoid scratching the door, do not use a sharp or
metallic object to pry the brand badge from the door.
2. Rub a small amount of liquid dish soap over any adhesive
residue with your fingers. Rinse the door with warm water
and dry with a soft cloth.
3. Cut the template along the dotted lines that match the
shape of the brand badge.
4. Align the edges of the template with the side and top of the
freezer door and tape the template to the door.
NOTE: When the template is correctly aligned, the hole in
the door, where the handle was, will be within the cutout of
the template, as shown.
5. Using the cutout as a guide, press the brand badge onto the
freezer door making sure that the hole is completely
covered.
6. Slowly remove the template.
12
All manuals and user guides at all-guides.com
IMPORTANT: To comply with American Disabilities Act (ADA)
guidelines, fully retract the rollers into the cabinet to lower the
refrigerator.
Your refrigerator has two front adjustable rollers – one on the
right and one on the left. If your refrigerator seems unsteady or
you want the doors to close easier, adjust the refrigerator's tilt
using the following instructions:
1. Remove the base grille. See the Base Grille graphic in
2. Use a socket driver to adjust the leveling screws. Turn the
3. Open both doors again to make sure they close as easily as
4. Replace the base grille.
If the space between your doors looks uneven, you can adjust it
using the following instructions:
1. Depending on your model, remove the top hinge cover.
2. Have someone hold the door in place or put a spacer
3. Replace the top hinge cover, if removed in Step 1.
Adjust the Doors
Door Closing
"Refrigerator Doors." The two leveling screws are part of the
front roller assemblies, which are at the base of the
refrigerator on either side.
leveling screw to the right to raise that side of the
refrigerator or turn the leveling screw to the left to lower
that side. It may take several turns of the leveling screws to
adjust the tilt of the refrigerator.
NOTE: Having someone push against the top of the
refrigerator takes some weight off the leveling screws and
rollers which makes it easier to adjust.
you like and that they stay closed. If not, tilt the refrigerator
slightly more to the rear by turning both leveling screws to
the right. It may take several more turns.
NOTE: To keep the refrigerator level, you should turn both
leveling screws the same amount.
Door Aligning
Loosen the top hinge screws using a ⁵⁄₁₆" socket or wrench.
between the doors while you tighten the top hinge screws.
