Remote Control Mode; Dmx Mode - Zzipp ZZFM3000 Manual De Ususario

REMOTE CONTROL MODE

The device can be managed remotely using the remote control included. To do this, plug
the wireless receiver into the connection on the rear of the unit. Please note that the device
cannot be controlled by remote control if it is connected to DMX.
The remote control has 2 or 4 buttons: Press and hold one of the buttons to trigger a
permanent fog emission. To stop the fog output, release the button.

DMX MODE

Resistance 120 ohm // ¼ w between pin 2 (DMX-) and pin 3 (DMX+) of the last fixture.
Connect the DMX input of your device to the DMX output of your DMX controller, your DMX
software or the DMX output of a device already in your DMX chain. Always use a DMX cable
with impedence 110 Ohm for this connection. Address the device according to your DMX
configuration. The following table shows the respective DMX modes of the individual devices
with the corresponding values and functions:
DMX CHANNEL
CH1
6
The remote control has 2 or 4 buttons:
Press and hold one of the buttons to trigger a permanent fog
emission. To stop the fog output, release the button
DMX SCALE
000-005
006-255
FUNCTION
OFF
1-100% FOG OUTPUT