Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Cleaning
and Applying
Detergent
IMPORTANT:
Use detergents
designed
specifically
for pressure
washers.
Household detergents could
damage the pump.
CAUTION
• Starting
the engine
without
all the hoses
connected
and
without
the water
turned
ON will damage
the pump.
• Damage
to equipment
resulting
from failure
to follow
this
instruction
will void warranty.
To apply detergent follow these steps:
1.
Review ProjectPro
TM
nozzle use.
2.
Prepare detergent solution as required by
manufacturer.
3.
Place filter end of detergent siphoning tube into
detergent container.
I
CAUTio.
1
• When
inserting
the filter into a detergent
solution
bottle,
route the tube
so as to keep it from inadvertently
contacting
the hot muffler.
4.
Make sure black ProjectPro
TM
cleaning detergent
nozzle is installed.
NOTE: Detergent cannot be applied with the high
pressure nozzles (Yellow, Orange or Red).
5.
Make sure garden hose is connected to water
inlet. Check that high pressure hose is connected
to spray gun and pump and start engine.
6.
Apply detergent to a dry surface, starting at lower
portion of area to be washed and work upward,
using long, even, overlapping strokes.
7.
Allow detergent to soak in between 3-5 minutes
before washing and rinsing. Reapply as needed to
prevent surface from drying. DO NOT allow
detergent to dry on (prevents streaking).
IMPORTANT:
You must flush the chemical injection
system after each use by placing the filter into a
bucket of clean water, then run the pressure washer in
low pressure for 1-2 minutes.
Pressure
Washer
Rinsing
For Rinsing:
1.
Engage trigger lock on spray gun.
2.
Remove black cleaning detergent nozzle from
nozzle extension.
3.
Select and install desired high pressure nozzle
following instructions "How to Use ProjectPro
TM
Nozzle System".
4.
Keep spray gun a safe distance from the area you
plan to spray.
WARNING
,
,
Keep spray nozzle between 8 to 24 inches away from
cleaning surface.
Operate this unit on a stable surface.
Be extremely careful if you must use the pressure
washer from a ladder, scaffolding or any other relatively
unstable location.
Firmly grasp spray gun with both hands when using high
pressure spray to avoid injury when gun kicks back.
Apply a high pressure
spray to a small area and
then check the surface for damage.
If no damage
is
found, you can assume
it is okay to continue
rinsing.
Start at top of area to be rinsed, working
down with
same overlapping
strokes as you used for cleaning.
Cleaning
Detergent
Siphoning
Tube
If you used the detergent siphoning tube, you must
flush it with clean water before stopping the engine.
1.
Place chemical injection siphon/filter in a bucket
full of clean water.
2.
Engage trigger lock on spray gun.
3.
Attach black cleaning detergent nozzle.
4.
Flush for 1-2 minutes.
5.
Shut off engine.
6.
ALWAYS point gun in a safe direction and
squeeze spray gun trigger to release retained high
water pressure.
iMPORTANT: Spray gun traps high water pressure,
even when engine is stopped and water is disconnected.
Automatic
Cool Down System
(Thermal
Relief)
If you run the engine on your pressure washer for
3-5 minutes without pressing the trigger on the spray
gun, circulating water in the pump can reach
temperatures above 125°F. The system engages to
cool the pump by discharging
the warm water onto
the ground.
13
Tabla de contenido
