Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Q. IEC INLET: Connect included power cord to a grounded outlet
in accordance with input power voltage and frequency specified
beside inlet. Universal 100V-240V operation.
R. POWER: Turns amplifier on and off.
S. MUTE: Mutes power amp. When in MUTE mode, XLR line output
remains active for studio or "quiet stage" use, and POWER JEWEL
(P) illumination changes from red to amber.
T. OUTPUT POWER: Selector switch offers full power (85 watts) and
five other attenuated wattage settings that tailor room/venue
overall loudness. Set amp front-panel channel volume to personal
preference for tube-emulated response, then set OUTPUT POWER
to preferred level.
U. CABINET SIM: When using XLR BALANCED LINE OUTPUT (X), this
switch offers three different tonal options—a flat, uncolored amp
signal without speaker cabinet emulation (OFF); and two impulse
response (IR) profiles emulating different speaker/microphone-
placement combinations:
IR PROFILE 1: Dynamic microphone close-mic'ed at edge of
speaker cone center cap for pronounced attack and definition. IR
created using a Shure® SM57 microphone.
IR PROFILE 2: Dynamic microphone close-mic'ed at edge
of speaker cone center cap for increased bass response and
smoother midrange. IR created using a Sennheiser® MD 421
microphone.
TYPE
PR 5184
POWER REQUIREMENTS
450W (max)
POWER AMP OUTPUT
200W into 4Ω (simulates 85W tube amp performance)
INPUT IMPEDANCES
Input 1 (both channels): 1MΩ
XLR LINE OUT IMPEDANCE
600Ω
SPEAKER
2 12" Celestion® G12 NEO Creamback, 8Ω (PN 7713555000)
FOOTSWITCH
Two-button Tone Master (included, PN 7716005000)
COVER
Fitted cover (included, PN 0050250000)
DIMENSIONS AND WEIGHT
Width: 26.16" (66.4 cm)
REAR PANEL
V. BALANCED LINE OUTPUT LEVEL: Adjusts output level of XLR
BALANCED LINE OUTPUT (X) for external devices and systems (i.e.,
PA and recording gear), whether mic or line level.
W. GROUND LIFT: When using the XLR BALANCED LINE OUTPUT (X),
engaging this button may eliminate hum or buzz resulting from
connection to improperly grounded equipment.
X. XLR BALANCED LINE OUTPUT: For balanced connection to
external devices and systems (i.e., PA and recording gear). XLR line
output remains active when amp is in MUTE mode (S).
Y. FOOTSWITCH: Connect included two-button footswitch for
reverb and tremolo on/off here.
Z. USB PORT (NOT SHOWN): For firmware updates, a USB port is
located on the underside of the chassis beneath the OUTPUT
POWER section. Visit fender.com/firmware/support for periodic
firmware updates that improve and enhance the Tone Master
experience.
All non-FMIC product names and trademarks appearing in this
manual are the property of their respective owners and are used
solely to identify the products whose sounds were studied during
IR development for this product. The use of these products and
trademarks does not imply any affiliation, connection, sponsorship,
or approval between FMIC and with or by any third party.
SPECIFICATIONS
Input 2 (both channels): 136kΩ
Height: 20.24" (51.4 cm)
Depth: 10.35" (26.3 cm)
Product specifications subject to change without notice.
2
Weight: 33 lbs. (15 kg)
Tabla de contenido
