Rear Panel - Fender MB-1200 Instrucciones De Funcionamiento

D. PARALLEL SPEAKER OUTPUTS -
Use any combination of these out-
puts to connect speaker cabinets.
Each Speakon ® con-
nector can accom-
modate two speakers
using a 4–pole "Y-cable."
The recommended speaker config-
urations below provide the optimal
2–ohm total impedance load:
(one 2Ω cabinet)
(two 4Ω cabinets)
(one 4Ω and two 8Ω cabinets)
(four 8Ω cabinets)
E. IEC POWER CORD SOCKET - Connect only the
supplied special high-capacity power cord to a grounded
AC receptacle in compliance with the voltage and
frequency ratings specified on the rear panel of your
MB-1200.
F. BALANCED (1/4") LINE INPUT - Plug your preamp
output into this jack when using an instrument cable
with mono (TS) or stereo
Tip=(+), Ring=(–), Sleeve=Ground. This jack will disable the
XLR jack-{G}.
TYPE:
PART NUMBERS:
POWER REQUIREMENT:
POWER OUTPUT:
INPUT IMPEDANCE:
INPUT SENSITIVITY:
POWER AMP PASS THRU:
POWER CORDS:
RECOMMENDED SPEAKERS:
DIMENSIONS:
WEIGHT:

Rear Panel

(TRS) plugs;
Specifications
PR 535
2147500000 (120V, 60Hz) US,
2147506000 (230V, 50Hz) EUR,
1800W
1200W RMS into 2Ω @ 1%THD
18kΩ balanced
1V RMS (0dBV)
OUTPUT IMPEDANCE: 220Ω,
0069133000 (120V, 60Hz) US,
0047251000 (230V, 50Hz) EUR,
810 Pro (2217200000),
HEIGHT: 3.5 in (8.9 cm),
35 lb (15.9 kg)
Product specifications are subject to change without notice.
G. BALANCED (XLR) LINE INPUT - Plug your preamp
output into this jack when using a microphone cable
with standard
balanced microphone or 1/4" TRS cable will normally
provide a better Signal-to-Noise ratio (hum-free,
cleaner sound).
H. POWER AMP PASS THRU OUTPUTS - When using
one preamp to drive multiple power amps, use these
jacks to connect to the inputs of additional power
amps. The signal at each of these jacks is an exact,
buffered replica of the signal connected at the input
{F} or {G}. (Again, while a typical mono TS guitar
cable is adequate, using a balanced TRS cable will
ensure hum-free operation.)
2147503000 (240V, 50Hz) AUS,
2147507000 (100V, 50Hz) JPN
NOMINAL LEVEL: 0dBV
0047250000 (240V, 50Hz) AUS,
0069142000 (100V, 50Hz) JPN
410 Pro ST/SL (2217100000 / 2217000000),
WIDTH: 19.0 in (48.3 cm),
XLR connectors. Use of a
2147504000 (230V, 50Hz) UK,
0047249000 (230V, 50Hz) UK,
Bassman ® 212 (2217300000),
DEPTH: 15.0 in (38.1 cm)
7