Rear Panel - Fender Blues-Junior III Instrucciones De Funcionamiento

I. POWER CORD
Connect to a grounded outlet in accordance
with the voltage and frequency ratings specified on the rear
panel of your amplifier.
J. FOOTSWITCH JACK
equipment) to enable remote selection of the FAT boost circuit.
The FAT switch {C} on the control panel is disabled when the
footswitch is connected.
K. SPEAKER JACK
Connection for the internal speaker –or– an
external speaker cabinet.
An 8 speaker load must always be connected to the Speaker
!
jack when the unit is ON to prevent damage to the amplifier.
L. TUBE STABILIZER
A shock-absorbing stabilizer is installed
on the output tubes to minimize the tube vibration and
microphonics that normally develop over time. The stabilizer
can be used with all output tubes compatible with your Blues
Junior™ III amplifier.
M. FENDER® GROOVE TUBES®
amplifier comes equipped with the highest quality tubes
available, sourced from various manufacturers worldwide.
Because of occasional irregularities in supply, the specific tube
type used in each amplifier is subject to change without
notice.
TYPE:
PART NUMBERS:
POWER REQUIREMENT:
POWER OUTPUT:
INPUT IMPEDANCE:
TUBES PRE-AMPLIFIER: 1–Fender Groove Tube 12AX7 (P/N 001-3341-000)
OUTPUT: 2–Fender Groove Tubes EL84 (P/N 004-1255-000)
FUSE:
SPEAKERS:
FOOTSWITCH (OPTIONAL):
DUST COVER (OPTIONAL):
DIMENSIONS HEIGHT: 16 in (41 cm)
WIDTH: 18 in (46 cm)
DEPTH: 9 13/16 in (25 cm)
WEIGHT:
Plug in a footswitch (optional
Your new Blues Junior III
Specifications Specifications
PR 295
223-0500-000 (120V, 60Hz)
223-0503-000 (240V, 50Hz) AUS
223-0505-000 (220V, 50Hz) ARG
223-0507-000 (100V, 50/60Hz) JPN
180W
15W RMS minimum into 8 at 5% THD, 1kHz
1M
Internal (non-user serviceable)
1–12" 8 Fender Special Design "lightning bolt" speaker by Eminence® (P/N 007-9527-000)
1–button, FAT switch (P/N 099-4049-000)
Fitted cover (P/N 005-4912-000)
31 lb (14.1 kg)
Product specifications are subject to change without notice.
fender.com

Rear Panel

Rear Panel
When replacing the EL
tube markings on the original tubes factory supplied with
your amplifier. For example, EL
but are not limited to: GT-EL
The installation of a different type may require significant
adjustment by a qualified technician to avoid reduction in
performance and tube life.
Additionally, Fender Groove Tubes tests and
sorts our EL
measured performance. The sorted tubes are
labeled with a fine rating of –
labeled with a coarse rating color of BLUE, WHITE
or RED. A pair of matched EL
the same fine rating (and coarse rating, if applicable) as
the original tubes will be the perfect replacement. However,
replacement tubes with a fine rating within one number of the
original tubes can be used without rebiasing the amplifier.
If you have questions or concerns, please contact your Fender
dealer or authorized service center.
N. FUSE NOT SHOWN
fault, your Blues Junior III amplifier is protected by an internal
fuse. If the unit should suddenly stop working, take it to an
authorized service center to have the fuse replaced and the
cause of the electrical fault inspected.
output tubes, please note the specific
output tube types include,
-R; GT-EL
output tubes based on their
and may also be
output tubes with
In the unlikely event of an electrical
223-0501-000 (110V, 60Hz) TW
223-0504-000 (230V, 50Hz) UK
223-0506-000 (230V, 50Hz) EUR
223-0509-000 (220V, 60Hz) ROK
2–Fender Groove Tubes 12AX7 (P/N 007-0228-000)
-S; ST-EL -R; etc.
7 7