Idiomas disponibles
Idiomas disponibles
Initial Startup
The sensor is connected to the pump and the pump is
displayed in the "Devices" view in the "Connected" tab.
Note: During set-up you will need the last 4 digits of your
sensor's and pump's serial numbers.
Alternative: Connect Sensor Only
If you do not have a pump with Bluetooth
use the sensor with a PLC as described in application
option 3, follow the steps below.
Prerequisites:
DULCONNEX Blue App is installed on your mobile
„
device. You cannot set up or operate the sensor
without the app.
Bluetooth
is enabled on your mobile device.
„
®
The sensor is connected to power.
„
Procedure:
1. Open DULCONNEX Blue on your mobile device.
2. Switch to the "Devices" view.
3. Tap on
All Bluetooth devices that are nearby are displayed.
4. Tap on + next to the sensor's name.
The sensor will be connected to the app. If the con-
and want to
nection is successful, a message appears.
®
5. Enter device PIN.
Note: The PIN is the last 4 digits of the sensor's serial
number.
The sensor is connected to the app and is displayed in
the "Devices" view in the "Connected" tab.
+
.
13
EN
