Idiomas disponibles
Idiomas disponibles
INSTRUCTIONS FOR USE
WARNING - PERSONAL INJURY AND/OR EQUIPMENT DAMAGE HAZARD:
To prevent patient and/or user injury and/or equipment damage, read and
understand all instructions presented in this manual before using the Power-
Lift Stirrups. Follow each step in the order presented in these instructions. If you
need technical assistance additional instructions, call STERIS.
To prevent patient and/or user injury and/or equipment damage, apply
Power-Lift Stirrups only to U.S. standard side rails like those equipped on the
Amsco@ 3080/3085 SP surgical tables. Figure 2-3. Power-Lift Stirrups Release
Handle
Attaching PowerLift Stirrups:
Complete each step in the order presented below and attach the Power-Lift
Stirrups to a surgical table as follows:
1. Review Figure 2-1 through Figure 2-4 and become familiar with product before
proceeding.
2. Ensure rail clamp (see Figure 2-1) jaw is fully open by rotating clamp locking
handle in a counter-clockwise motion.
3. Position Power-Lift Stirrup onto side rail with locking handle to outside.
4. Move stirrup to desired location on side rail (adjacent to patient's hip).
5. Tighten rail clamp by rotating clamp locking handle clockwise.
6. Repeat Steps 2 through 5 for other side.
7. With adequate help, place both legs into stirrups simultaneously.
8. To adjust stirrups for patient's legs, proceed as follows:
a. Loosen boot lock handle or linear adjustment handle.
b. Gently slide boot up or down the bar, slightly flexing patient's knees to
approximately 170 degrees.
c. Maintain ankle, knee, and opposing shoulder in a relatively straight line.
NOTE: For a typical patient, the thigh and foot are abducted at
approximately the same angle.
d. To reposition stirrups, grasp release handles with palms down and twist your
thumbs toward ceiling (see Figure 2-3). When desired degree of lithotomy
and/or abduction is obtained, simply release handles.
e. When satisfied with position, tighten boot lock handle.
NOTE: Do not use Power-Lift Stirrups in Reverse Trendelenburg unless the Reverse
Trendelenburg Restraint Strap accessory is used (see Operator Manual P 150830-
523 for more information).
Document Number: 80028296
Version: A
Page 13
Issue Date: 19 MAR 2020
Ref Blank Template: 80025118 Ver. E
