Idiomas disponibles
Idiomas disponibles
EN
will shorten the service life of the generator.
Limit operation requiring maximum power to 30 minutes.
For continuous- operation, do not exceed the rated power .
In either case. the total power requirements (VA) of all appliances connected must be considered.
Appliance and power tool manufacturers usually list rating information near the model number or
serial number.
4) AC Operation
①. Start the engine
②. Switch the AC circuit breaker ON
③. Plug in the appliance
Most motorized appliances require more than their rated wattage for startup.
Do not exceed the current limit specified for any one receptacle. if an overloaded circuit causes the
AC circuit breaker to switch OFF, reduce the electrical load on the circuit, wait a few minutes and
then reset the circuit breaker.
5) DC OPERATION
DC Terminals
The DC terminals may ONLY be used for charging 12 volt automotive type batteries.
The terminals are colored red to identify the positive (+) terminal and black to identify the negative
(-)terminal. the battery must be connected to -he-generator DC terminals with the proper polarity
(battery positive to generator red terminal and battery negative id the generator black terminal).
With DC Circuit Protector
With DC Fuse
DC circuit protector (or DC Fuse)
The DC circuit protector(or DC Fuse) automatically shuts off the DC battery.
Charging circuit when the DC circuit is overloaded, when there is a problem with the battery, or the
connections between the battery and the generator are improper.
8
