Basic Procedure - Kenwood DPX795BH Manual De Instrucciones

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Installation/Connection
Part list for installation
(A) Mounting sleeve ( ×1 )
(C) Trim plate (only for Toyota car) ( ×1 )
(E) Round head screw ( ×6 )
(
)
(G) Wiring harness ( ×1 )
(B) Trim plate ( ×1 )
(D) Extraction key ( ×2 )
(F) Flat head screw ( ×6 )
(
)

Basic procedure

1
Remove the key from the ignition switch, then disconnect the
terminal of the car battery.
2
Connect the wires properly.
See "Wiring connection" on page 33.
3
Install the unit to your car.
See the following "Installing the unit (without mounting sleeve)".
4
Connect the
terminal of the car battery.
5
Press B SRC to turn on the power.
6
Reset the unit. (Page 4)
Installing the unit (in-dash mounting)
Do the required wiring.
(Page 33)
Dashboard of your car
Bend the appropriate tabs to hold the
mounting sleeve firmly in place.
31
ENGLISH
Tabla de contenido
loading

Tabla de contenido