In addition, any seal must be
returned after the interventions
necessary for
the Gas change.
NX52A7422CS
NX52A7
(1)
(2)
NX52 5411CS
A
NX52A5412CS
(3)
• Replace the control knob and heat the oven for 15
minutes.
• Then turn the control knob to the minimum setting 150.
• Remove the control knob again.
• Now, through the gas tap opening in the control panel,
adjust the internal setting screw until a stable flame is
burning correctly.
Loosen the setting screw to increase the gas flow or
tighten it to decrease the gas flow.
The setting is correct when the height of the small
flame is around 3 to 4 mm.
In the case of a connection to nature gas, loosen the
setting screw.
In the case of a connection to liquefied gas, tighten the
setting screw.
Turn the setting screw clockwise mean tighten it. Turn
the setting screw anticlockwise mean loosen it.
• Refit the control knob.
• Make sure that the flame does not go out when the gas
flow is changed quickly from maximum to minimum
and vice versa, and when the appliance door is opened
and closed.
Adjust the primary air for oven burner
The primary air is correctly set when the flame is
stable and blue/green.
Proceed as follows:
• Take down the oven burner, loosen the screw and turn
the cover clockwise or anti-clockwise.
• The correct cover position can be determined .
(2)
(3)
1.8 KW
1.5 KW
1.0 KW
1.8 KW
2.2 KW
1.5 KW
1.0 KW
1.8 KW
EN-17
3.3
3.3
2.8
3.0
1.75
1.75
5.0
5.0
2.2
2.2
2.8
3.0
1.75
1.75
4.3
4.3
