Idiomas disponibles
Idiomas disponibles
See drawing 200
See drawing 201
Disposal at end-of-life
Operation and
maintenance manual
7.5 Repairs
The Product must only be opened and repaired by the Technical
Service Personnel for the fuse change. All other repairs to be done by
Interrupt the power supply before doing any maintenance jobs.
Making any changes to this device is forbidden.
The only repair job with which the technical assistance personnel are
charged is the fuse change.
To access the fuses in the ceiling version, open the bar cover as
indicated in point 5 of paragraph 7.4.
To access the fuses in the floor version, lift the ring (7), remove the
screws (8) and lift the cover (9).
Remove the screw fuse carrier (5) from the terminal board and replace
the fuse (6) making sure it is replaced with another of the same type.
If necessary, Tecno-gaz will provide the wiring diagrams, the list of
component parts, the descriptions, setting instructions or other
information to assist the technical assistance personnel in repairing the
parts of the Product indicated as reparable by the technical assistance
personnel.
If the above indications are not enough to solve the problem, contact the
after-sales service.
7.6 Disposal after use
Comply with applicable laws on waste disposal. This product must not
be disposed of in standard waste disposal bins. To avoid risks for the
environment and health deriving from the dispersion of polluting
substances in the environment, separate the various internal component
parts such as iron, aluminium, plastic and electrical material, and
dispose of these through authorized channels so as to ensure correct
recycling.
MU_029_EN
Rev.0
the manufacturer.
07/11/18
EN
Page 22 of 35
