Idiomas disponibles
Idiomas disponibles
CLEANING AND MAINTENANCE
CLEANING YOUR KETTLE
Unplug it.
Let it cool down and clean it with a damp sponge.
• Never immerse the kettle, its base, the cord or the electric plug in water: the
electrical connections or the switch must not come into contact with water.
• Do not use scouring pads.
• Do not wipe the display while plugged in, it may cause unexpected start-up.
DE-SCALING
De-scale regularly, preferably at least once a month or more frequently if your
water is very hard. Temperature detection in the kettle may be affected by
limescale.
To de-scale your kettle:
• Using white vinegar which can be bought from hardware stores:
– Fill the kettle with ½ litre of white vinegar,
– Leave to stand for 1 hour without heating.
• Using citric acid:
– Boil ½ litre of water,
– Add 25 g of citric acid and leave to stand for 15 min.
• Empty your kettle and rinse 5 or 6 times. Repeat if necessary.
IN THE EVENT OF PROBLEMS
THERE IS NO EVIDENT DAMAGE TO YOUR KETTLE
• The kettle does not work
– Check that your kettle is properly connected.
– The kettle has been switched on without water or an accumulation of
scale has caused the overheat cut-out to operate: allow the kettle to cool
and fill it with water. Descale first if scale has accumulated.
Switch it on: the kettle should start working again after about 15 minutes.
IF YOUR KETTLE HAS BEEN DROPPED, IF IT LEAKS OR IF THERE IS VISIBLE
DAMAGE TO THE POWER CORD, THE PLUG OR THE BASE OF THE KETTLE
Return your kettle to your After-Sales Service Centre, only they are authorised
to carry out repairs. See the guarantee conditions and list of centres in the
booklet supplied with your kettle. The type and serial number are shown on
the bottom of your kettle. This guarantee covers manufacturing defects and
domestic use only. Any breakage or damage resulting from failure to comply
with the instructions for use is not covered by the guarantee.
8
• The manufacturer reserves the right to modify the characteristics or
components of its kettles at any time in the interests of the consumer.
• Do not use the kettle if damaged. No attempt must be made to dismantle
the kettle or its safety devices.
• If the supply cord is damaged, it must be replaced by the manufacturer, its
after-sales service centre or a similarly qualified person, in order to avoid
any danger.
PREVENTION OF DOMESTIC ACCIDENTS
For a child, a burn or scald, even if slight, can sometimes be serious.
As they grow up, teach your children to beware of hot liquids to be found in
the kitchen. Position the kettle and its supply cord well to the rear of the work
surface, out of the reach of children.
If an accident does occur, run cold water over the scald immediately and call a
doctor if necessary.
• In order to avoid any accident: do not carry your child or baby at the same
time as drinking or carrying a hot drink.
Malfunction
Causes
description
Kettle does not start
The kettle is
heating
not positioned
correctly on the
power base.
Kettle is heating but
Connection
the control panel
issue with the
lights are off.
indication lights
and/or the
indicator light is
damaged.
display "E1"
Temperature
sensor failure.
display "E3"
Temperature
regulation error.
Solutions
Reposition the kettle on the
power base.
Send to an authorised service
centre for repair.
Send to an authorised service
centre for repair.
Switch off and unplug the
kettle for 1 minute, then plug
in and switch the kettle on
again. If the problem repeats,
please send to an authorised
service centre for repair.
9
EN
