Wesco WS2539 Manual Del Usuario página 33

speed will increase accordingly. The "10" position is for the highest speed. (See Fig.F3)
Always choose the correct speed for your work according to the material. Select the right speed for the
accessory in use. Practice with scrap materiel first.
To stop the tool, dail the switch to "0" position.
2. USING ACCESSORIES
The chart below lists the description, use speed and scope for some of the small articles supplied
together with the tool by category. To achieve best performance of the tool, it is strongly recommended
that you read it prior to operation, failure to adhere to this may cause accessories to fail.
TOOL
EN
DESCRIPTION
Grinding Stones
Various head styles,
on shafts
Diamond Bits
Various head styles
Wool Wheel
Mounted to screw drill
Sanding/Cutting wheels
Mounted to cutting wheel
fixture
Note:
DO NOT over tighten screw
Sanding Roll
Mounted on hold for rubber
wheel (9)
Note:
To fit the sanding roll, firstly loosen the small screw on top of the hole
for rubber wheel, this will allow the rubber to relax. Slide the sanding
roll onto the holder.
To secure, simply tighten the screw and the rubber roll will swell,
gripping the sanding drum.
SPEED FOR USE ON
Full speed Metal
22,000/min Mild steel
Full speed Wood Zinc
22,000/min Plastic Nickel
Copper Mild steel
Half speed Metal
11,000/min Mild steel
Metal
Half speed
Mild steel
11,000 /min
Wood
Full speed Metal
22,000/min Mild steel
33