Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
Battery assembly
1. Insert the battery (7) into the cordless orbital sander
fitting and press the battery until you hear the "click
noise" of the battery lock/unlock button (6). At this
point the battery is completely secured;
2. To remove, press the Battery lock/unlock button and
pull out the battery;
Only use VITO 20V lithium batteries.
Battery charging
1. Place the battery in the charger as if you placed it in
the cordless orbital sander;
2. Plug the charger plug into the socket and let it charge.
Sometimes at the end of charging, both the battery and
the charger may be hot, which does not mean that they
are malfunctioning.
Allow the battery to cool down before putting it in the
machine.
Dust extraction adapter assembly
Connect the dust extraction adapter (2) to the vacuum
cleaner connector. Connect the dust extraction adapter
to a suitable dust extraction system.
Dust bag assembly
1. Insert the dust bag (4) into the dust extraction
adapter (2) by gently turning it until it fits into place.
2. The dust is extracted directly into the dust bag
through the sanding disc and the sanding pad (5).
3. Turn and pull the dust bag simultaneously to remove
it again.
For safety reasons it is essential that you use the
dust bag or a dust extraction system.
Installation and changing of sanding disc
▪ Use only sanding disc with the corresponding
dimensions and corresponding perforated holes.
▪ Place the sanding disc on the sanding pad (5). Make
sure that the perforated holes on the abrasive paper
match the sanding pad.
▪ To remove the sanding disc, simply pull it out.
OPERATING INSTRUCTIONS
When working with the cordless orbital sander,
you should consider some precautions and
operating procedures:
▪ Hold the sander with both hands. Loss of control of
the sander can cause serious injury;
▪ When working on loose or small parts, use fixing
devices to secure the parts securely and securely;
▪ Do not apply excessive pressure to the sander against
the workpiece/object. If the speed decreases
abruptly, reduce the pressure on the sander
immediately;
▪ When the application tool locks, immediately switch
off the tool. Avoid the high reaction torques;
▪ Never put the sander down until the rotary tool has
come to a complete stop;
▪ Wear hearing protection when using the sander.
Exposure to noise may cause hearing loss;
▪ Switch the sander off immediately if any of the
following problems occur:
- Leakage of lubricant through ventilation holes;
- Damage to the sander housing;
- Damage to the "ON/OFF" switch;
- Appearance of smoke or characteristic burning smell;
Variable speed dial
The orbital sander is equipped with a variable speed dial
(3), with 6 speed levels.
Level 1: Lower speed;
Level 6: Higher speed;
Starting and stopping the cordless orbital sander
1. To switch on the sander, press the ON/OFF switch
(1), from position 0 to I;
2. To switch off the sander, press the "ON/OFF"
switch, from position I to 0;
25
