Attaching The Accessories; Start Up; Water Connection - Kärcher HD 6/15 G Manual Del Usuario

Attaching frame parts
Figure 2, see cover page
 Adjust the push handle on the appli-
ance.
 Fasten the push handle with a mush-
room head bolt and washer and nut.
 Repeat process on the opposite side.
 Slide the wheel onto the axle.
 Slide adjusting collar onto the shaft and
tighten the screw.
 Repeat process on the opposite side.

Attaching the Accessories

 Lever out the safety clip of the hand spray
gun using a screw-driver (Picture A).
 Place the hand-spray gun upside down
and insert the end of the high pressure
hose till the end. Ensure that the lose
disc falls right below on the hose end
(Picture B).
 Press the safety clip back into the hand-
spray gun. The hose can be pulled out
max. 1 mm if it has been installed cor-
rectly. Otherwise, it means the disc has
been installed wrongly (picture C).
 Connect spray lance to trigger gun.
 Install nozzle with nozzle screw at the
spray lance.
 Fasten the high pressure hose to the
high pressure connection.
Only HD 8/23 G:
Figure 3, see cover page
 Fasten the storage compartment to the
push handle.
Figure 4, see cover page
 Secure both hose switches.

Water connection

Connection to the water supply
WARNING
Observe regulations of water supplier.
According to applicable regula-
tions, the appliance must never be
used on the drinking water net
without a system separator. A suit-
able system separator by KÄRCHER or al-
ternatively a system separator according to
EN 12729 type BA must be used.
16

Start up

Water that was flowing through a system
separator is considered non-drinkable.
For connection values refer to technical
specifications.
 Connect the supply hose (minimum
length 7.5 m, minimum diameter 3/4") to
the water connection point of the ma-
chine and at the water supply point (for
e.g. a tap).
Note:
The supply hose is not included.
 Open the water supply.
Suck in water from vessel
DANGER
Health hazard!
Never suck water from a drinking water
container.
Risk of explosion, risk of poisoning!
Never suck in liquids which contain sol-
vents like lacquer thinner, petrol or oil. The
spray mist of solvents is highly inflamma-
ble, explosive and poisonous.
ATTENTION
Risk of damage! Do not suction unfiltered
water.
 Connect suction hose (minimum diame-
ter 3/4") with filter (accessory) to the
water connection point.
 Remove air from appliance before oper-
ation.
Deaerating the appliance
 Open the water supply.
Note:
If a suction hose with a check valve or filter
is used, the hose must be filled with water.
 Start the engine according to the oper-
ating instructions of the engine manu-
facturer.
Deaerate the appliance:
Unscrew the nozzle.
Switch on the appliance and let it run
until the water exiting is bubble-free.
At the end let the appliance run for ap-
prox. 10 seconds - then switch off. Re-
peat the procedure for a couple of
times.
 Switch off the appliance and fit the noz-
zle again.
– 4
EN