Black and Decker HNVC220BCP Manual De Instrucciones página 11

Idiomas disponibles

Idiomas disponibles

Dry pick up
For everyday spills of dry material.
-
Do not fill the dust bowl
intake chute.
Optimizing the suction force
In order to keep the suction force optimized, the filters must
be cleared regularly during use.
Emptying and cleaning the product
Removing the dust bowl and filters (Fig.
D, E)

WARNING:
should be cleaned regularly.
1. Press the bowl release button
straight off as shown in Fig. D.
3
2. While holding the dust bowl over a trash can, pull out
the filter
10
to empty the contents as shown in Fig. E.
3. Insert cleaned filter
10
4. To replace the dust bowl, push it back onto the handle
until it clicks firmly into place.

WARNING:
without the filters. Optimum dust collection will only
be achieved with a clean filter.
Fig. D
2
Fig. E
Cleaning the dust bowl and filter
The dust bowl and filter can be washed in warm soapy
water.
1. Make sure the filter
10
before installing.
beyond the end of the
3
The filter is reusable and
and pull the dust bowl
2
into the dust bowl
.
3
Never use the appliance
3
10
3
and the dust bowl
3
are dry
Accessories (Fig. F)
Your hand vac may be supplied with some of the following
accessories:
-
A brush tool
5
for furniture and stairs.
1. A crevice tool
is built into the dust bowl and can be
11
extended as shown in Figure F by pulling the extension
piece until it locks into position.
2. To store the crevice tool, press the release button
and push the crevice tool
shown in Figure F.
Fig. F
11
12
D
Fitting
1. Insert the appropriate accessory into the front of the
dust bowl
4
as show in Figure G.
2. Make sure the accessory is fully pushed in.
Fig. G
4
5
Replacing the filters
The filters should be replaced every 6 to 9 months and
whenever worn or damaged. Replacement filters are
available from your BLACK+DECKER dealer.
Visit www.blackanddecker.com to locate dealers.
Remove the old filters as described in Cleaning
the Filters.
Fit the new filters as described in Cleaning the Filters.
(cat. no: HNVCF10)
These fit all units. When these filters reach the end of their
lifespan they must be disposed of at a local recycling center.
English
12
11
into the dust bowl as
9
loading