Idiomas disponibles
Idiomas disponibles
5. Coolant Pump Locking Pin On PSA models insert the (E) into one of the holes in the pulley and
on through to the hole in the pump body in order to fix the pump position to remove the pulley.
Tum the engine over, by hand, in the direction of normal engine rotation, to TDC No.1 cylinder.
6. Remove the blanking plug from the engine block which provides
access to install the appropriate Flywheel Locking Tool and check
that the timing hole in the flywheel is aligned to this access hole.
7. Check that the timing holes for the camshaft sprockets are visible
through the slotted holes in the sprockets and are aligned as follows:
-Left hand sprocket in the 5 o'clock position.
-Right hand sprocket in the 7 o'clock position.
If not, then tum the crankshaft over one turn.
NOTE: Reference to left hand or right hand camshaft is as viewed when
looking directly at the camshaft sprockets.
8. Automatic LRi Jaguar, Manual LRi Jaguar, and PSA
Flywheel Locking Tools
Install the appropriate Flywheel Locking Tool into the access
hole and locate the 'pin' of the Locking Tool into the timing hole
in the flywheel.
9. NOTE: The 'pin' of (B) (manual transmission) Locking Tool is offset
(Fig.A), and once it has been inserted, the Locking Tool is fixed in
position by securing it at the starter motor bolt position.
A
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
B
Tel.: 02196 720480
Fax.: 02196 7204820
F
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
