Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Inserting/Replacing the Battery
Always replace all batteries
WARNING
!
at the same time. Only
use batteries from one brand and with the
identical capacity.
Remove the batteries from the tool when not
using it for extended periods. When storing
for extended periods, the batteries can corrode
and discharge themselves.
Alkaline batteries are recommended for
the tool.
The numbering of the product features shown
refers to the illustration of the tool on the graphic
page.
1 Exit opening for laser beam
2 On/Off switch
3 Tripod mount 5/8"-11
4 Tripod mount 1/4"-20
5 Latch of battery lid
6 Battery lid
7 Laser warning label
Range Radius X-Axis
Range Radius Y-Axis
Range Radius X-Axis
Range Radius Y-Axis
Self Leveling Range (typically)
Out of Level Warning
Manual Leveling Base
Slope Off Level Operation
Intended Use
The tool is intended for determining and checking level.
Technical Data
Preparation
To open the battery compartment 6, slide the
latch 5 in the direction of the arrow and fold the
battery lid up. Insert the batteries.
When inserting, pay attention to the correct
polarity according to the representation on the
inside of the battery lid.
The batteries become weak, at approximately
6 hours battery life remaining. Flashing Laser –
(ON 0.2 secs and OFF 0.2 secs for a 30 second
period then ON until battery is exhausted,
repeats on initial startup).
Features
8 Serial number
9 Laser target plate*
10 Laser receiver (LR 3)
11 Rod clamp
12 Laser viewing glasses*
13 Tripod (BT 152)
14 Leveling rod (GR 8 C)
* The accessories illustrated or described are
not included as standard delivery.
X Axis (standard range mode on the LR 3)
Y Axis (standard range mode on the LR 3)
X Axis (long range mode on the LR 3)
Y Axis (long range mode on the LR 3)
Flashing Laser (ON 3.0 secs, OFF 0.5 secs)
-7-
3 ft to 196 ft (1 m to 60 m)
3 ft to 65 ft (1 m to 20 m)
66 ft to 260 ft (20 m to 80 m)
66 ft to 260 ft (20 m to 80 m)
± 4 degrees
Not required
Yes
Tabla de contenido
