Idiomas disponibles
Idiomas disponibles
EN
8.10 Door Reversibility
Before connecting the appliance to the power supply you should check, whether the door
swing must changed from left (as delivered) to right, if this is required by the installation
location and the usability.
1
2
4
3
5
7
8
9
10
12
11
14
13
Assembly steps
8.6
1. Provide necessary tool.
2. Unplug the appliance.
3. Open the upper and lower handle covers on the right
side of the door.
4. Pry the white slider slightly.
5. Take out the 2 push rod, and put the handle cover
6
back on.
6. Remove the 2 rubber plugs on the left side of the
door and put it with the removed push rods for step
20.
7. Remove 7 screws and hinge cover. Be careful not
to tear the door cable.
8. Unplug the connection cable.
9. Remove 3 hinge screws and the left upper hinge,
and remove the door carefully.
10. Place a cardboard box or cloth under the door and place
the door horizontally. Remove the right door end cover,
take the left end cover from the accessory bag. Install
it on the top left side of the door.
11. Remove 2 screws on the right bottom of the door. Re
-move 2 screws, door stopper and axe cover on the
left bottom of the door.
12. Take door stopper from last step and the right axe
Fix 2 screws also on the other side of the door.
13. Put the back of the cabinet down after placing thicker
pads underground. Remove 4 screws and the lower
hinge.
14. Unscrew the axe cover.
8 - Installation
(Fig. 8.6):
25
