Idiomas disponibles
Idiomas disponibles
7.2
STOP THE MACHINE
1. Release the bail switch to stop the machine.
WARNING
Wait until the blades fully stop before you start the machine
again. Do not quickly turn the machine off and on.
WARNING
Always remove the safety key and battery pack after you
complete the work.
7.3
EMPTY THE GRASS CATCHER
1. Stop the machine.
2. Remove the safety key.
3. Remove the battery pack.
4. Open the rear discharge door and hold it.
5. Hold the grass catcher by its handle and unhook it from
the door rod.
6. Close the rear discharge door.
7. Empty the grass catcher.
7.4
OPERATE ON SLOPES
WARNING
Do not mow on the slopes with incline more than 15°. If
you are not comfortable, do not mow on a slope.
•
Do not go up and down on a slope, mow across the face
of the slope. Be careful when you change the direction on
a slope.
•
Monitor the holes, ruts, rocks, and other hidden objects
that can cause you to fall. Remove all obstacles such as
rocks and tree limbs.
•
Make sure that your footing is stable. If you are out of
balance, release the bail switch immediately.
•
Do not mow near drop-offs, ditches, or embankments.
7.5
OPERATION TIPS
•
Do not try to override the operation of the start button or
bail switch.
•
Do not tilt the machine when you start it.
•
Do not put hands or feet near or below the turning parts.
•
Keep the discharge chute clean.
•
Do not cut wet grass.
•
Higher blade height is necessary for new or thick grass.
•
Clean the bottom of the mower deck after each use.
Remove grass clippings, leaves, dirt, and other debris.
English
8
MAINTENANCE
Remove the safety key and battery pack from the machine
before maintenance.
Keep the motor and battery pack free from grass, leaves or
too much grease.
Use only approved replacement parts.
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
8.1
GENERAL MAINTENANCE
•
Before each use, examine the machine for damaged,
missing, or loose parts such as screws, nuts, bolts and
caps.
•
Tighten correctly all the fasteners and caps.
•
Clean the machine with a dry cloth. Do not use water.
8.2
REPLACE THE BLADE
Use only approved replacement blades.
Wear heavy gloves or wind cloth around the blade when
you touch the blade.
1. Stop the machine.
2. Make sure that the blade is fully stopped.
3. Remove the safety key and battery pack.
4. Turn the machine on its side.
5. Use a piece of wood to prevent the movement of the
blade.
6. Remove the mounting screw with a wrench or socket.
7. Remove the blade.
8. Install the new blade. Make sure that the arrows engage
the holes in the blade.
9. Put in the mounting screw and tighten it.
11
WARNING
WARNING
CAUTION
CAUTION
CAUTION
WARNING
WARNING
EN
