Idiomas disponibles
Idiomas disponibles
torque adjustment ring is set on a lower setting.
Make the setting as follows:
1 - 4
For driving small screws
5 - 9
For driving screws into soft material
10 - 18 For driving screws into soft and hard material
For heavy drilling
6. USING THE LED LIGHT
The sight light allows you to keep a clear view under less
illuminated circumstances. To turn on the light simply
press the on/off switch. When you release the on/off
switch, the light will be off.
LED is also a battery capacity indicator. It will flash when
power gets low.
7. DRILLING
When drilling into a hard smooth surface, use a center
punch to mark the desired hole location. This will prevent
the drill bit from slipping off center as the hole is started.
Hold the tool firmly and place the tip of the bit at the point
to be drilled. Depress the switch trigger to start the tool.
Move the drill bit into the workpiece, applying only enough
pressure to keep the bit cutting. Do not force or apply side
pressure to elongate a hole.
WARNING: Tungsten carbide drill bits
should always be used for concrete and
masonry. When drilling in metal, only use HSS
drill bits in good condition. Always use a
magnetic bit holder (not included) when using
short screwdriver bits. When screw-driving,
apply a small quantity of liquid soap or similar
to the screw threads to ease insertion.
EN
PROBLEM SOLUTION
1. WHY DOES THE DRILL NOT TURN ON
WHEN YOU PRESS THE SWITCH?
The forward/reverse rotation control, which is on top of
the trigger, is positioned in the lock function. Unlock the
forward/reverse rotation control by putting it into the
required rotation position. Push the trigger and the drill
will start to rotate.
2. THE DRILL STOPS BEFORE THE SCREW IS
COMPLETELY TIGHTENED. WHY?
Verify the torque position of the torque adjusting ring, you
can find the torque-adjusting ring between the chuck and
the drill body. Position 1 is the lowest torque (screw
driving force) and position 18 is the highest torque (screw
driving force). Position
the torque adjusting ring to a higher position to reach
the best result.
3. REASONS FOR DIFFERENT BATTERY
PACK WORKING TIMES
Charging time problems, as above, and having not used a
battery pack for a prolonged time will reduce the battery
pack working time. This can be corrected after several
charge and discharge operations by charging & working
with your drill. Heavy working conditions such as large
screws into hard wood will use up the battery pack energy
faster than lighter working conditions. Do not re-charge
your battery pack below 0
affect performance.
MAINTENANCE
Your tool requires no additional lubrication or maintenance.
There are no user serviceable parts in your power tool.
Never use water or chemical cleaners to clean your power
tool. Wipe clean with a dry cloth. Always store your power
tool in a dry place. Keep the motor ventilation slots clean.
Keep all working controls free of dust. Occasionally you may
see sparks through the ventilation slots. This is normal and
will not damage your power tool.
For battery tools:
The ambient temperature range for tool and battery use and
storage is 0
C-45
C.
o
o
The recommended ambient temperature range for the
charging system during charging is 0
is for drill operation. Regulate
C and above 40
C as this will
o
o
C-40
C.
o
o
19
