Sears Kenmore 110.3316 Serie Manual De Uso Y Cuidado página 19

First try the solutions suggested here for assistance and to possibly avoid a service call.
If you experience
Washer not performing as expected (cont.)
Incorrect dispenser operation
Single-dose laundry packet
not dissolving
Control panel not
responding to touch
Error Code Appears in Display
"LF" (F8E1) (too long to fill)
appears in display
F#E# code (F-type error
code) appears in display
F1E1 ACU (Appliance
control fault)
F2E3 UI/ACU mismatch
F3E1 Water level
sensing failure
F5E2 Lid lock will not lock is
lid lock failure
F5E3 Lid cannot unlock
F6E2 or F6E3
Communication Error:
UI cannot communicate
F8E6 (Lid opened) appears
in display
"drn" "dr" (F9E1) (drain
pump system problem - long
drain) appears in display
TROUBLESHOOTING
Possible Causes
Clogged dispensers or laundry products
dispensing too soon.
Adding laundry packet incorrectly.
Control Lock is on.
Washer taking too long to fill. Drain ex-
tends more than 4.5" (114 mm)
into standpipe.
System error code.
Internal ACU failure.
ACU/UI initialization error.
Pressure sensor on ACU failure.
An item in the load may be keeping the
lid from locking.
Objects on washer lid prevent it
from unlocking.
ACU or UI synchronization error.
Washer lid left open.
Washer taking too long to drain water.
Drain extends more than 4.5" (114 mm)
into standpipe.
Do not overfill dispenser. Overfilling causes immediate dispensing.
Load dispensers before starting a cycle.
It is normal for small amounts of water to be remain in dispenser at the
end of the cycle.
Homes with low water pressure may result in residual powder in the
dispenser. To avoid, select a warmer wash temperature if possible,
depending on your load.
Be sure laundry packet is added to washer basket before adding clothes.
Follow the manufacturer's instructions to avoid damage to your items.
Be sure to turn the control lock off when you want to modify settings or
use the control panel.
Check plumbing for correct drain hose installation. Use drain hose form
and attach securely to drainpipe or tub. Do not tape over drain opening.
See Installation Instructions.
Touch POWER to clear the code and exit cycle. Then touch POWER,
select cycle, and then touch and hold START/PAUSE/Unlock Lid to start
washer. If code appears again, call for service.
Call for service.
Call for service.
Call for service.
Check for items directly under the lid.
Remove objects, such as baskets of laundry, from top of washer.
Remove power from the washer. Let washer set for 5 minutes for the
washer to completely power down. Apply power to washer and check for
error codes. If the error code persists call for service.
Close the lid and touch Power to clear the display. If the lid is left open
for more than 10 minutes, the cycle will reset and water in the washer
will drain.
Check plumbing for correct drain hose installation. Use drain hose form
and attach securely to drainpipe or tub. Do not tape over drain opening.
Lower drain hose if the end is higher than 96" (2.4 m) above the floor.
Remove any clogs from drain hose. See Installation Instructions.
Solution
19