Andis LCL Instrucciones De Uso Y Cuidado página 4

16. WARNING: Never touch both terminals on clipper with
metal objects and/or body parts, as short circuit may
result. Keep away from children. Failure to comply
with these warnings could result in fire or serious injury.
SAVE THESE INSTRUCTIONS
THIS PRODUCT INTENDED FOR PROFESSIONAL USE
OPERATING INSTRUCTIONS
CHARGING CLIPPER
The AC adapter is intended for use with Andis Model LCL lithium-ion battery with a
rated capacity of 4.5V
Plug the AC adapter into a 100-120V, 50-60 cycle AC outlet, or as noted on the unit.
Plug the adapter cord directly into the receptacle on the bottom of the clipper (Figure A).
The clipper ON/OFF switch must be in the OFF position for the battery to charge. The
green light on the clipper will turn ON when the clipper is charging. When clipper is
fully charged, the green light will turn OFF.
The clipper has not been charged at the factory. Please charge the clipper for
3-5 hours before FIRST use for maximum performance. When battery is fully
charged, clipper can be used for up to 2 hours of continuous run time. After
first use, clipper will fully charge in a minimum of 90 minutes.
FAILURE TO CHARGE
1. Make sure voltage is present at the wall outlet (confirm with an appliance you
know is working).
2. Make sure ON/OFF switch on the clipper is OFF.
3. Check to make sure adapter cord is plugged firmly into clipper.
4. If failure to charge still exists, return clipper to Andis or an Andis authorized service
station for examination and repair or replacement.
4
1.2A. Remove the clipper and AC adapter from the carton.