Idiomas disponibles
Idiomas disponibles
Connection/Installation
Ñ
Equalizer Control
You can adjust equalizer by selecting the
optimized setting for each category.
1
Touch [EQ / SW Level].
2
Touch the screen and set the Graphic
Equalizer as desired.
Gain level (area in dotted frame)
■
Adjust the gain level by touching each
frequency bar.
You can select a frequency bar and adjust its
level by [R], [S].
[ALL SRC]
■
Apply the adjusted equalizer curve to all
sources. Touch [ALL SRC] and then touch
[OK] on the confirmation screen.
■
[Memory]
Saves the adjusted equalizer curve as "User1"
to "User4".
■
[Initialize]
Initialize (flatten) the current EQ curve.
[Bass EXT] (Bass Extend Settings)
■
When turned on, the frequencies lower than
62.5 Hz is set to the same gain level (62.5 Hz).
[SW Level]
■
Adjust the subwoofer volume.
■
[Pops]/[Easy]/[Top40]/[Jazz]/[Powerful]/
[Rock]/[Flat]/[Bass Boost]/[User1]/
[User2]/[User3]/[User4]
Recall the preset EQ curve.
26
Connection/Installation
This section is for the professional installer.
For safety's sake, leave wiring and mounting to
professionals. Consult the car audio dealer.
Before Installation
Before installation of this unit, please note the
following precautions.
# WARNINGS
• If you connect the ignition wire (red) and
the battery wire (yellow) to the car chassis
(ground), you may cause a short circuit, that
in turn may start a fire. Always connect those
wires to the power source running through
the fuse box.
• Do not cut out the fuse from the ignition wire
(red) and the battery wire (yellow). The power
supply must be connected to the wires via
the fuse.
# CAUTION
• Install this unit in the console of your vehicle.
Do not touch the metal part of this unit during
and shortly after the use of the unit. Metal part
such as the heat sink and enclosure become
hot.
NOTE
• Mounting and wiring this product requires
skills and experience. For best safety, leave the
mounting and wiring work to professionals.
• Do not install the unit if it becomes an obstacle
to driver performance.
• Adjust the panel position not to become an
obstacle to driver performance.
• Adjust the panel position so that the panel can
be moved to an angle that allows an SD card
to be inserted and removed.
• Make sure to ground the unit to a negative 12V
DC power supply.
• Do not install the unit in a spot exposed to
direct sunlight or excessive heat or humidity.
Also avoid places with too much dust or the
possibility of water splashing.
• Do not use your own screws. Use only the
screws provided. If you use the wrong screws,
you could damage the unit.
