Repair; Specific Safety Rules For Arc Inverter Welders; Features; Installation - Urrea SOLI9200-BV Manual De Usuario

• Make sure that there is no metal-like foreign
body to enter the welding machine.
• No violent vibration in the welder's surround-
ing area.
• Make sure that there is no interference with
the surrounding area at the installation site.
• Make sure whether there is enough power
supply to make the welding machine work
properly. Any power source required to access
the welder must be installed with some protec-
tive equipments.
• The welder should be installed on the hori-
zontal surface and if it over 15°, there should
be added some anti-dump set.

REPAIR

• Repair of Arc Welding should be carried
out only by qualified personnel. The repair or
maintenance performed by a qualified person-
ano can create risk of injury.
• When repairing the machine using only gen-
uine replacement parts. Follow the instructions
in the maintenance section of this manual. The
use of unauthorized parts or failure to follow
maintenance instructions may create a risk of
electric shock or injury.
SPECIFIC SAFETY RULES FOR
ARC INVERTER WELDERS
• Make sure that the welding machine has reli-
able earth wire connection;
• Make sure that there is no short circuit con-
nection with welder's both outputs;
• Make sure that there is always sound output
and input wire connection instead of exposing
it outside.
Regular check needs to be conducted by the
qualified personnel after the welder has been
installed over a period of six months, which in-
volves as follows:
· Routine cleaning needs to be done to make
sure that there is no such abnormal condition
as loose connection happening in the weld-
ing machine.
· The external parts installed with the welder must
guarantee that the welder works properly.
· Check the welding cable to see if it can con-
tinue to be used before it is worn out.
· Replace the welder's input cable as soon as it
is found to be broken or damaged.
E N G L I S H •

FEATURES

WELDER STRUCTURE
This welder use the movable carton like struc-
tures: The upper part in the front is equipped
with a welding current regulation knob (1), a
power arc knob (2), a power indicator light (3),
abnormal indicator light (4), working indica-
tor (red) and a display scren, while the lower
part is furnished with the current output "+"
quick connector and "-" quick connector (6).
The back side is installed with power switch,
cooling fan and power source lead-in wire. On
the top there is a handle for the convenient of
easy transport (7). When you open the cover,
there is one primary transformer, one piece of
printed circuit board. The bottom part is sup-
plied with output reactor, primary transformer
and etc. Installed in the middle part is a radia-
tor with power elements.
4
3
5
6

INSTALLATION

Connect the power source cable at the back board
of the welder into the single phase 120/220 V power
network with breaker; 120/220 V power sources
is strictly prohibited to the welder which will se-
verely damage the welder, otherwise the user
should take the consequences for it.
Electrode holder.
Work piece.
Stow wood. Earth cable.
U se r's m a n ua l
7
2
1
Safety
grounding.
Single phase power wire.
9