aquatechnik BSB 32 Instrucciones De Utilizacion página 18

MANUAL RETURN OF COUPLING TOOL BSB 32
If the machine must be brought back to initial position
without completing the stroke, follow these simple
steps:
unscrew protection nut located on the emergency
1)
return device (C) as indicated in picture 14;
2) overturn the protection nut and screw it (by the
special threaded hole) to the emergency return
device (C) (picture 15);
3) pull protection nut downward until the equipment
is released (picture 16);
unscrew protection nut, overturn it and screw it
4)
back in order to restore its initial position;
5) restart work.
MAINTENANCE
- Keep the conical pin clean and lubricated (by using aquatechnik grease, Item#
71391).
- In order to clean the equipment, use a cloth slightly soacked with a common, non-
aggressive detergent. DO NOT USE acid substances, thinners, solvents, and
powdered products which may damage its components.
- For a good operation of the Coupling tool BSB 32 , it is recommended to perform
a servicing every two years conducted at aquatechnik mechanical dept.
- Any servicing work on the Coupling tool BSB 32 shall be performed at
aquatechnik mechanical dept. Any alteration of the equipment or its components
involve the cancellation of the warranty.
- In case of consistent loss of oil from the equipment, send immediately the Coupling
tool BSB 32 to aquatechnik mechanical dept. for subsequent inspection and
repairing. (Warning: avoid that leaked oil comes into contact with the eyes or skin.
Do not inhale or ingest. Do not disperse into the environment).
- Avoid that the equipment get wet; water and liquids in general can damage the
electrical circuits.
Warning: During maintenance operations, make sure that the equipment is
disconnected from power sources (battery or outlet).
ENGLISH
18
BSB 32
(patented)
Picture 14
Picture 15
Picture 16