Automated Cleaning - D Devices D LOCATOR Manual De Instrucciones

minutes after the completion of the operation. The steps are as follows:
1. Remove the measuring wire from the device, and rinse away the dirt on the
surface of product with pure water (or distilled water/deionized water);
2. Dry the product with a clean, soft cloth and place it in a clean tray.
Note:
The water used here must be pure water, distilled water or deionized water.
6.2 Preparation before cleaning Steps:
Tools: tray, soft brush, clean and dry soft cloth
put them into a clean tray.
2. Use a clean soft brush to carefully brush the copper needle at the end of the
on the surface, and put them into a clean tray.The cleaning agent can be pure
water, distilled water or deionized water.
6.3 Cleaning
The cleaning should be performed no later than 24 hours after the operation.
The cleaning can be divided into automated cleaning and manual cleaning.
Automated cleaning is preferred if conditions permit.

6.3.1 Automated cleaning

15883.
product.
•The cleaning procedure is suitable for the product, and the irrigating period is
•Do not clean the product with ultrasound.
It is recommended to use a washer-disinfector in accordance with EN ISO
27