Operation; Start The Machine; Stop The Machine; Led Light - Powerworks P24HG Manual Del Operario

WARNING
Be careful of the high temperature. Do not touch the nozzle
until it cools.
3

OPERATION

WARNING
Always wear eye protection.
WARNING
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
3.1

START THE MACHINE

Figure 5
The machine can not work until the lock out button is
pushed fully to the left or right.
1. Push the lock out button to the left or right.
2. Push and hold the trigger to turn the heat gun ON.
3.2

STOP THE MACHINE

1. Release the trigger to stop the machine.
The machine runs on for a short time before switching off.
Wait until the motor stops after you stop the machine.
3.3

LED LIGHT

Figure 6
The LED light illuminates when the trigger is depressed.
It turns off after a delay when the trigger is released.
3.4

HANGER

Figure 7
The machine can be hung in a suitable position.
1. Pull up the hanger.
2. The hanger can be rotated after being pulled up. Rotate
the hanger as needed.
3. Hang the machine in the suitable position.
WARNING
Do not operate while hanging!
3.5

ACCESSORIES

Figure 1
FLAT NOZZLE
English (Original Instructions)
NOTE
NOTE
For wider and larger air outlet, use the flat nozzle. For
example, dry paint, remove label, etc.
REDUCTION NOZZLE
For smaller air outlet, use the reduction nozzle. For example,
remove components on circuit board, etc.
HOOK NOZZLE
Use the hook to protect surrounding objects from heat
radiation. For example, use the hook to protect other wires
from heat radiation when one wire among a bundle needs to
be processed.
4

MAINTENANCE

CAUTION
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
CAUTION
Do not use strong solvents or detergents on the plastic
housing or components.
WARNING
Remove the battery pack from the machine before
maintenance.
4.1

CLEAN THE MACHINE

CAUTION
The machine must be dry. Humidity can cause risks of
electrical shocks.
• Clear the unwanted material out of the air vent with a
vacuum cleaner.
• Do not spray the air vent or put the air vent in solvents.
• Clean the housing and the plastic components with a
moist and soft cloth.
5

TECHNICAL DATA

Voltage
Air Volume
Maximum Temperature
BTU Heat Rating
Weight Without Battery
Battery Model
Charger Model
5
24V
200 L/min
550°C ±10%
400 W
0.64 kg
P24B2/P2448B4 and other
BAG series
P2448C and other CAG ser-
ies
EN