Connectors And Controls; Label On The Rear Panel - Gima DIATERMO 106 Manual De Instrucciones

GIMA SpA
§
Unpack the equipment and carefully study the documentation and operating instruction supplied. The mains input voltage,
indicated up the equipment mains input, must agree with the local mains voltage (mains frequency: 50-60 Hz). The correct
voltage setting is selected as shown in fig. E
§
Insert the correct fuses in the module according to the following table:
Mains Voltage
Mains Voltage
§
To insert the fuses pull out the fuse holder from the mains module with the help of a screwdriver (Fig.1 and Fig. 2) - clip
the fuses into the holder (Fig. 3) - replace the holder into the module.
§
Connect the mains cable to a mains outlet that has good earth connection.
OPERATION OF THE EQUIPMENT WITHOUT EARTH CONNECTION IS FORBIDDEN
§
Position the equipment such that there is sufficient room around it. Air circulation must not be restricted in any way.
§
Operate the equipment only in dry surroundings. Any condensation that occurs must be allowed to evaporate before putting
the equipment into operation. Do not exceed the permissible ambient temperature or humidity.
§
Environmental conditions:
§
Temperature: from 10°C up to 40 °C
§
Relative moisture: from 30% up to 75%
§
Atmospheric pressure: from 70 kPa up to 106 kPa (10 PSI up to 15 PSI)

4.1 LABEL ON THE REAR PANEL

The requirements for the safety of H.F. surgical equipment ask that some technical data and graphic symbols must be printed on the
cabinet or on at least one of the panels of the generator unit to define its features and oversee its condition of work.
Manuale d'Istruzione / Instruction's Manual / Manual de Instrucciones
110-120 V~ Fuse
220-240 V~ Fuse

4. CONNECTORS AND CONTROLS

MA126IGBa
2 x 2AT (Anti-surge) Type
2 x 1AT (Anti-surge) Type
DIATERMO 106
5 x 20 mm
5 x 20 mm
25