Disengaging The Chain Brake; Maintaining The Chain Brake - Stihl MSA 161 T Manual De Instrucciones

English
WARNING
No chain brake device prevents kickback. This device is
designed to reduce the risk of kickback injury, if activated, in
certain kickback situations. For the chain brake to remain in
good working order, it must be properly maintained, @ 7.2.
In the event of a kickback, the chain brake is designed to
engage if the left hand contacts the front hand guard and
pushes it forward.
The chain brake is also designed to be activated by the
inertia of the front hand guard if the forces are sufficiently
high. When the brake is activated by inertia, the hand guard
accelerates toward the bar nose, even if your hand is not
behind the hand guard.
Engaging the chain brake locks the chain. To manually
engage the chain brake:
► Push the front hand guard to the
front handle.
You will hear an audible click when the front hand guard
reaches the locked position.

17.2 Disengaging the Chain Brake

WARNING
Before disengaging the chain brake and switching on your
chain saw, be sure that the guide bar and saw chain are
clear of you and all other obstructions and objects, including
the ground, @ 6.5.
44
position, away from the
Disengaging the chain brake unlocks the chain. To
disengage the chain brake:
► Pull the front hand guard to the
front handle.
You will hear an audible click when the front hand guard
reaches the unlocked position. In this position, the chain
brake is disengaged and the saw can be switched on.

17.3 Maintaining the Chain Brake

WARNING
An improperly maintained chain brake may increase the time
needed to stop the saw chain after activation, or it may not
activate or stop the chain at all, @ 7.2. The chain brake is
subject to wear, depending on the amount of usage,
conditions under which the saw is used and other factors.
Excessive wear will reduce the effectiveness of the chain
brake and can render it inoperable.
► Your chain saw should be returned to your authorized
STIHL servicing dealer for periodic inspection and
servicing of the brake system according to the following
schedule:
– Heavy Usage: every 3 months
– Part-Time Usage: every 6 months
– Occasional Usage: every 12 months
17 The Chain Brake
position, toward the
0458-791-8621-C