Hilti TE 2 Manual De Instrucciones página 21

5 Operation
Fitting the side handle
CAUTION
Risk of injury The depth gauge, if fitted but not used, may hinder the operator.
▶ Remove the depth gauge from the tool.
CAUTION
Risk of injury Loss of control over the rotary hammer.
▶ Check that the side handle is fitted correctly and tightened securely. Check that the
clamping band is engaged in the groove provided on the tool.
TE 2-M
Fitting / removing the chuck
Fitting/removing the drill bit or other accessory: SDS chuck
Note
Use of unsuitable grease may cause damage to the product. Use only the
recommended grease supplied by Hilti.
TE 2-M
Fitting/removing the drill bit or other accessory: Quick-release chuck
Adjusting the depth gauge
Note
Always pay attention to the maximum length of the depth gauge.
Drilling with hammering action (hammer drilling)
TE 2-S
Light hammering action
TE 2
TE 2-S
Drilling
TE 2-M
Drilling in first gear
Forward / reverse
Risk of damage Actuation while the tool is running may result in damage to the gearing.
▶ Do not operate the forward / reverse switch while the motor is running.
6 Care of the product
WARNING
Electrical hazards! Improper repairs to electrical parts may lead to serious injuries.
▶ Electrical parts may be repaired only by trained electrical specialists.
▶ Keep the product, especially its grip surfaces, clean and free from oil and grease. Do not use
cleaning agents containing silicone.
▶ Never operate the product when the air vents are blocked. Clean the air vents carefully using a dry brush.
Do not allow foreign objects to enter the interior of the product.
▶ Clean the outside of the electric tool at regular intervals with a slightly damp cloth. Do not use a spray,
steam pressure cleaning equipment or running water for cleaning.
▶ Clean the dust shield on the chuck with a dry, clean cloth at regular intervals. Clean the sealing lip by
wiping it carefully and then grease it again lightly with Hilti grease. It is essential that the dust shield is
replaced if the sealing lip is damaged.
or drilling in second gear
2
3
4
5
6
7
7
7
7
8
15