Tabla de contenido
Idiomas disponibles
Idiomas disponibles
7.2 Removing Internal Printer Paper Jams
If paper jams in the printer and cannot be removed by pressing the paper
advance button (6), the printer must be disassembled. Do not pull the
paper backwards through the printer and never put utensils or tools into
the paper exit slot.
When paper is jammed in the printer, follow these steps to remove the jam
(refer to figures 15c & 16):
1.
Power the STATIM 5000
2.
Using scissors, cut the paper between the
roll and the paper feed slot (5).
3.
Remove the paper roll
in the loading position.
4.
Using a #1 Phillips screwdriver, remove the three screws
printer cover
5.
Note the orientation of the exposed printed wiring board
paper roll arm
6.
Gently lift the printed wiring board upwards and away from the printer
door. Exercise care while handling the board. The printer is integral to
the wiring board. Do not place strain on the connections of the ribbon
cable soldered to the board. Do not remove the connector of the
flexible cable from the connector header on the board. The paper drive
mechanism on the underside of the wiring board is now exposed.
7.
Using a pair of tweezers or fine needle-nosed pliers, carefully remove
the paper from the mechanism.
When the paper is removed, reassemble the printer:
1.
Carefully snap the paper roll arm, in the loading position, back into the
clips on the printer door (1).
2.
Place the printed wiring board back into position on the printer door.
Note the alignment of the mounting holes
mounting bosses
rests between the locating ribs
3.
Ensure that the flexible cables (11),
printer door and the wiring board.
4.
Place the printer cover on the printer door. Ensure that the flexible
cables are not pinched between the cover and the door. The power
button and the paper advance button must protrude
through the openings in the cover and operate freely.
5.
Using a #1 Phillips screwdriver, secure the printer cover to the printer
door with the three screws retained during the disassembly procedure.
Do not over-tighten these screws.
6.
Plug your STATIM 5000 into the wall receptacle. Turn the power switch
to the
7.
Press the printer power button to the
printer following the procedures in Section 7.1 Installing Paper on the
Internal Printer.
SciCan Ltd.
Internal Printer
and unplug the unit.
OFF
from the paper roll arm
(3)
and remove the cover.
(8)
assembled on the printer door (1).
(4)
on the printer door. The black plastic printer body
(13)
(10)
position.
ON
and leave the arm
(4)
from the
(7)
and the
(15)
in the wiring board and the
(9)
on the inside of the printer door.
are not pinched between the
(14)
position. Load paper into the
ON
26
7
9
11
13
1
10
12
STATIM 2000/5000 Cassette Autoclave Operator Manual
8
15
14
10
4
Figure 16
Tabla de contenido
