Cleaning With Detergents - BE Power Equipment B4014VTBA Manual Del Operador

CLEANING WITH DETERGENTS

CLEANING WITH DETERGENTS
1. The black soaper nozzle must be installed on the spray gun wand. It is the
only nozzle that will draw soap through the pressure washer system.
2. The detergent being used must have thin viscosity (similar to water).
3a.For models without an onboard soap tank; fill a container with detergent and
place it next to the pressure washer. Connect the clear detergent suction tube
to the brass barb on the pressure washer pump, and put the end with the filter
into the detergent container.
3b.For models with an onboard soap tank; fill the soap tank with the detergent.
4. Turn on the pressure washer and spray the water. You will be able to see the
detergent moving through the suction tube. Once the detergent is spraying
out the nozzle, it will cause foam to appear.
5. When using detergent, spray the desired area and give it some time for the
soap to chemically breakdown the dirt chemically. Then, wash it off with water
before it dries. Do not let the detergent dry on the surface as it may result in
damage.
6. When you are finished using the detergent you must flush the detergent
injector system to prevent detergent residue from building up. To rinse, use
clean water (either in a separate container or in the onboard soap tank).
Spray for at least two minutes while drawing the clean water through the soap
system.
www.bepowerequipment.com 25