BE Power Equipment B4014VTBA Manual Del Operador página 22

6. Put engine switch to the ON position. On the Honda GX, Powerease, and
Kohler SH270 engines it will be switch on the side of the engine like the
picture below. The Kohler CH440 has the ON/OFF built into the fuel valve. For
the Honda GC and Vanguard engines move the throttle lever to maximum.
7. With one hand, squeeze the trigger of the spray gun, so the water is flowing.
Brace the pressure washer with your foot. With the other hand, grip the recoil
handle and slowly pull it out until you feel resistance. Pull briskly on the recoil.
You may have to pull it several times before it starts running.
8. Once the engine has warmed up, disengage the choke by moving the choke
lever all the way RIGHT on all models except the HONDA GC where the
choke tab is pushed all the way IN. If it stalls, then it needs to get warmer
before the choke is turned off. Restart the engine, let it warm up, and then try
turning the choke off again.
Important Note: The pressure washer has been designed to run at full throttle.
If you lower the throttle then the load-to-power ratio between the engine and
pump will be incorrect. This will cause undue strain on the system while pressure
washing, causing parts to wear quicker.
22
GAS ENGINE START PROCEDURE
∙ HONDA GX
∙ POWEREASE
∙ KOHLER SH270
Honda GC engine: Move throttle all
the way up to put in ON position.
Kohler CH440 engine: Move fuel
valve all the way to the right to put in
ON position.
Vanguard Engine: Move throttle
all the way left to put it in the ON
position.
www.bepowerequipment.com