TILSBERK DVISION Manual De Instrucciones página 48

Replacing the display
1
FIGURE 17 //
Replacing the display
1. Place a screwdriver under the side of the display holder (FIGURE 17/1) and carefully lift up the
display holder.
2. Remove the display holder and the damaged display (FIGURE 17/2) from the DVISION module.
3. Insert the new display into the DVISION module. Make sure that the alignment is correct. The
small ring on the display (FIGURE 17/3) should point to the narrow side of the DVISION module.
4. Insert the clamping wedge (FIGURE 17/4) into the support (FIGURE 17/5) on the display holder.
5. Place one side of the display holder on the DVISION module, then push and swing it back into
its position.
You have replaced the display.
2
T RO U B L ES H O OT I N G
4
3
5
47
EN