TILSBERK DVISION Manual De Instrucciones página 26

3. Lightly and evenly push the helmet adapter with the adhesive pad onto the helmet.
FIGURE 12 //
Example: straight and curved mounting surface
4. Check whether the helmet adapter sits correctly on the helmet. To do so, use the magnets to
attach the DVISION module to the helmet adapter.
The DVISION module must lie flush against the helmet adapter (FIGURE 12/1). There must be
no visible gap between the DVISION module and the helmet adapter (FIGURE 12/2a). A slight
curvature in the mounting surface can be compensated by the adhesive pad (FIGURE 12/1a).
Checking the position of the helmet adapter
5. Fold down the sun visor to check that the sun visor does not collide with the helmet adapter or
the DVISION module.
6. Put your helmet on as usual.
7. Attach the DVISION module to the helmet adapter using the magnets and fold down the display
at a 45° angle.
The display should be well visible in front of your right eye.
8. Push the operating button on the DVISION module to switch on the device.
A screen appears on the display.
INFO
If the mounting surface is curved and the helmet adapter does not sit
correctly against the mounting surface, choose the mounting variant
using Sugru (Chapter 3.6 on page 27).
I N - H E LM E T I N STA L L AT I O N
1a
1
2
2a
EN
25